CUSTOM STANDS FOR THE MAGNEPAN MMG and MG12
|Aesthetic Stands for the Magnepan MMG
1 Set comprises of 4 pieces of these beautiful black powdercoated heavy steel stands with spikes. They are thicker and slightly wider than the standard factory MMG / MG12 stands. Very sturdy.
Thickness: 10mm (0.4 inches)
Mounted on the lower setting they stand about 2½ inches off the ground. This was about the optimum height off the ground for an MMG / MG12. (Any more and the bass weakens). There is a higher setting adding 2 inches (total of 2 height settings).
|They have adjustable spikes.
The spikes will add about 1 inch. They are adjustable screw type spikes
and you can vary these by up to about +/- 0.5 inch. Effectively you can
raise the MMG / MG12 on these from 2½ inches to a little over 5 inches
off the floor. Also by adjusting the nut/screws on the front and back of
these spikes you can adjust speaker tilt forward or back.
Rear view shown on higher setting.
SUSPENDED / FLOATING IN THIN AIR LOOK
One of the early concepts in designing this stand was to enhance the simple panel design characteristic to Magnepan. What better way than to let it float. This is achieved by double decking the base on the design. When the bottom base is tucked beneath a carpet of the same color (as shown) the speaker panel looks as if it is suspended in thin air.
The weight of all 4 pieces is about 9kgs (nearly 20lbs). Having this
weight at the base makes the MMG / MG12 mounted on these stands a little more
difficult to tip over.
|PRICE: NZ$350 (approx US$210 / EUR160) excludes shipping.
NZ residents add 12.5% gst.
ESTIMATED SHIPPING COST:
To Order Click on link below to proceed to SSL then checkout.